Basic information
- Valve type: single acting, closed when idle
- Connection: female thread BSP-G 1 1/2 "
- Orifice (hole): mm
- Operating valve pressure: 0–25 bar
- Actuator operating pressure:6-8 bar
- Valve body material: AISI316L stainless steel
- Drive material: Polyamide
- Seat seal: PTFE
- Coil seal: PTFE
- Piston seal: FKM (fluoroelastomer)
- Medium temperature: –10~+150 °C
- Ambient temperature: –10 °C~+80 °C
- Viscosity: max 600 mm2/s
- Flow rate: m³/h
- Control air connection: internal thread BSP G 1/4 "
- Designed for water, liquids, water vapor (max. Saturated steam temperature according to the PTFE material used)
In case of long-term use of the valve at limit temperatures, it is necessary to consult with the supplier about the suitability of the valve.
SINGLE VALVE FUNCTIONING PRINCIPLE
This type of valve is widely used in operations requiring a restart in a short period of time, with the advantage of its rapid and accurate response. The valve is opened by compressed air.
Application areas of pneumatically controled valve
Wineries, breweries, dairy industry, beverage industry, food production, is widely used in pharmacy etc.
//Note:// A pilot valve must be purchased to operate the seat valve. You can find a suitable type in the section
More from the category
Pneumatically-operated Valves, Angle Seat - 45°, G-thread, Seal PTFE
Pneumatically-operated Valves, Angle Seat - 45° G…
Pneumatic actuators are supplied without plastic push-in fittings - section Pneumatic…
Pneumatically-operated Valves, Angle Seat - 45° G…
Pneumatic actuators are supplied without air exhaust and plastic plug-in fittings -…
Pneumatically-operated Valves, Angle Seat - 45° G…
Pneumatic actuators are supplied without air exhaust and plastic plug-in fitting -…
Pneumatically-operated Valves, Angle Seat - 45° G…
A pilot valve must be purchased to operate the seat valve. Pneumatic actuators are…
